problem retro -fitting tpms

Discussion in 'Audi TT Coupe / Roadster' started by para999, Jul 13, 2012.

  1. para999 Member

    bit of a story keep with me on this.
    bought the parts ie. wiring loom from kufatec, new switch bank from audi, 2nd hand tpms controller from ebay.de.
    took the car to audi indy to have it fitted.result cannot connect to controller. all instructions were followed to the letter by indy. live + negative + canbus connection.
    questions are:-
    the controller is 8JO 907 274 according to scan done on another car vcds says part no 8JO 907 274 C
    does the "C" bit make any difference ?
    the indy says its probably the controller thats faulty but as these units are over £200 new i don't fancy spending out if its not necessary,just checking alternatives.
    thanks
  2. Advertisement

  3. mike3141 Member

    The "C" is the revision designation so a "C" controller is a newer design than a controller which has no letter.
  4. para999 Member

    thanks for that so would you say a controller without the C should work just the same ?
  5. mike3141 Member

    You should check with a parts source to see exactly what controller would match your VIN.

Share Audi Forum with friends