pdc retrofit a3 2010 train drive can bus

Discussion in '8P platform' started by danikas, May 4, 2014.

  1. danikas Member

    Greetings all
    Does any one know if the PDC WITH P STEERING ASSIST will only work on the train can bus?
    Also is there an easy way to trace can bus drive train without removing the steering wheel?
    I cannot find a can bus drive train line except the one to the steering controller ...(and the can bus controller access is also done by removing the steering wheel :(
    I try connecting J446 on informatics can but it does not pick it up
  2. Advertisement

  3. danikas Member

    OK I got the answer myself, it only communicates on the drivetrain can bus so I had to find the can bus controller under the steering wheel (on the right by the console frame) and take pins 6/15 from PDC ASSIT to 16/6 of j533.I placed the module under the carpet end by the drivers seat side it is very convenience there and close access to the harness channels.(it fits perfect.)
    Once I finish my retrofits will upload a pdf.as before with the memory seats retrofit on my A4.
    MY on going projects A3 CABRIO 2010 :
    Retrofit PDC WITH STEERING ASSIST
    R8 REVERSE CAMERA WITH TRAJECTORY LINES
    AUTO LIGHTS
    AUTO DIMM MIRROR WITH RAIN /LIGHTS SENSOR
    RNS-E NAVI
    BLUE TOOTH
    ORIGINAL ALARM WITH MOVING SENSOR
    FULL ELECTRIC ROOF LATCH (CABRIO)
    HOME LINK
    TPM WITH RESET SWITCH.
    Cheers all.

Share Audi Forum with friends