danikas

hello can sm help me with the diagram or how to connect power and the k line to the hybrid tv on the all road 2010 a4 ?kufatec send me the red plug with the wires (red,brown,green)but they refused to give me any instructions !!
i dont know if i should bridge the red power +12 ,to the power of the amp or draw power from the fuse box.the kufatec plug with the red connection has very short cables so i imagine that i suppose to take power from the rack devices ?does the same goes for the diognostics line ?is this the green cable on the kufatec red plug ? item nu :37022.
am very disappointed with kufatec Germany ,they sold me the parts but they want give me any instructions....
thank you in advance

PetrolDave

The B8 A4 does NOT have K-line diagnostics, so there is NO K-line in your car!

__________________
06 RS4 Avant - Phantom Black

2010 EU RNS-E 8P0 035 193 C with A4 faceplate - with SDS (HW 070, SW 0150) - coded 309723
16GB SDHC card + CD changer and AMI ready to be fitted

BT 8P0 862 335 M - coded 10702 paired with HTC TyTN II (WM6.1)

Instruments ch 62 = 23
VCDS (VAG-COM) 908 + HEX-COM+CAN

danikas

ok maybe i used the wrong terminology ,what is the green thin wire that come with the power cables ?diognostics or triger or something?any way i have it connected to the radio power plug directly and it works fine(see it with vag com) however i cannot find the corect coding for the hybrid tv.any ideas?

PetrolDave

As I have said on here many times wire colours do not reliably indicate the function of the wire.

For that we need to know where the wire comes from - which pin of which connector?

__________________
06 RS4 Avant - Phantom Black

2010 EU RNS-E 8P0 035 193 C with A4 faceplate - with SDS (HW 070, SW 0150) - coded 309723
16GB SDHC card + CD changer and AMI ready to be fitted

BT 8P0 862 335 M - coded 10702 paired with HTC TyTN II (WM6.1)

Instruments ch 62 = 23
VCDS (VAG-COM) 908 + HEX-COM+CAN

danikas

[quote=PetrolDave;78662]As I have said on here many times wire colours do not reliably indicate the function of the wire.

For that we need to know where the wire comes from - which pin of which connector?

finaly done!!
i managed to performed a factory installation of a hybrid tv tuner to my new allroad a4 2010.
i think it is importand to mention the following :
the kufatec loom cable from tuner to boosters antenas suplied for the avant models is not correct ,the Antena cable on the left side is to short to fit were the amplifier is located(new all roads a4 have it on the far top left of the back left small window just next to the rear seat.)an extention fakra cable can rectify this.
coding for europe will be 0E020000.(got it on line by my friendly Audi dealer).
the power for the tv tuner comes from the radio power so it is red=12+
brown=12-,green is diognostics,colour code from the suplied kufatec red plug .kufatec does not supply any instructions but they are working on that.
once the tv is connected it will be automaticly detected by the MMI3G and works even if you dont vag com it...
the only problem was to connect the amplifier to the right back window antena ,and this was done by welding three small wires to the window antena..the others had the cables attached to the antenas and only the amplifiers had to be replaced.
the reception is fantastic and i pick up digital and analog receptions.
Also the new mmi 3g has the fakra green video connection even without tv or Rear camera :)

i have download some pictures on my profile sorry for poor quality,next project rear camera..

Ari